The Edit Feature will allow you to edit the tracking if the software did not capture each dot on every frame. To use this function, after a putt has been taken, click on the edit tab in the upper left section (see picture below).
|
Scroll through, using the scroll bar in the lower left section, until you reach the frame that did not have all the dots captured or has one captured incorrectly. Then go back one frame to see the order of where the Green, Blue and Red X's are (see picture below).
|
Now scroll ahead to the next frame where you want to edit the dots. Click on the Edit Frame bar in the lower right section. Determine which dot should have the Green X and in the magnified picture box on the right and click on the center of that dot. A yellow X will be placed there. Now move to the dot that should have Blue X and click on the center of that dot. A yellow X will be placed there. Now move to the dot that should have Red X and click on the center of that dot. A yellow X will be placed there. A box will pop up asking you to accept the changes, click yes and you are done with that frame. Keep in mind, the order of the software always goes Green, Blue, Red. The software automatically saves the changes you make. You can continue to another frame or go back to the main button in the upper left.
|
|
